Throttle Control Cable Adjustment

Install short cable back into shift bracket.

Throttle control cable adjustment.

Throttle freeplay is a terribly overlooked adjustment that can change both the reaction and comfort of your motorcycle. Remove the cable by opening the unit and unscrewing the lock screw on the handle. Adjusting and replacing the throttle cable can be done at any level of mechanic skill. Push the throttle to the full forward position.

If it is turned on and off as per your command then the adjustment is ok. With control shifter still in full forward full throttle position adjust brass trunion on control cable to fit onto easily onto shift bracket. This throttle valve cable is responsible for controlling the throttle lever providing movement to the car. You may like my other videos.

The throttle valve cable is used to control the line pressure downshifting and the feel of the shifting. If your boat and motor are still under warranty don t attempt to adjust the throttle cable. Many cars with automatic transmissions use a mechanical cable that runs from the transmission to the throttle linkage. Just type lsailor1 in the youtub.

Video showing the common methods of installing throttle and choke cables on both the auto choke and manual choke engines how to adjust them and how to chang. If adjusting your throttle cable doesn t eliminate problems with engine speed control have the issue looked into by your boat or motor dealer. Knowing how to adjust your throttle c. Take the boat to the dealer as soon as possible.

Adjust the forward cable barrel while the throttle cable is in the full forward position. Adjust the cable of the throttle in the endpoint and tighten the screws of the clamp. If the cable is too tight then the lever is unseated off the roller. If there is slack in the cable then you need to make another adjustment.

The manual says to spin trunion up to four 4 additional turns in one direction but i do not have that info at hand. Tighten the jam nut on the throttle cable with the wrenches. Ensure that the throttle arm at the motor travels to the throttle stops. Detach the cable from the throttle arm on the engine.

This video shows you how to install throttle and shift cables on a 1996 mercury 40hp outboard. Adjust the cable so it fits snugly between the studs which are pre mounted and hold the shift cable in position. Move the cable to a lower hole on the control if the lever travel is insufficient to reach full throttle. Push the throttle lever towards the slow position.

Step 1 remove the cable housings using a pair of pliers.